LS Billet Aluminum Valley Plate – Brushed

Overview

Perfect for carburetor swaps from fuel injection on GM LS Gen III engines. Eliminates factory knock sensors. Machined out of 1/4″ thick billet aluminum and available in brushed aluminum or black finishes. Includes stainless steel fasteners.

Features:

• Fits GM LS Gen III Engines
• 1/4″ Thick Billet Aluminum
• Counter Sunk Bolt Holes
• Includes Stainless Steel Fasteners

Important Notes:

• DOES NOT FIT GM LS GEN IV ENGINES

Disclaimer

OFF-ROAD USE ONLY

This product is legal for off road use and non pollution controlled vehicles (1965 & older); however, it has not been tested or approved by the California Air Resources Board (CARB) for highway vehicles in the state of California. By purchasing this product, buyer agrees it will not be used on pollution controlled vehicles in California, or in a state with similar emissions regulations.

WARNING: Cancer and Reproductive Harm – www.P65warnings.ca.gov

Resources

PART NUMBERS

• Brushed Aluminum: R5310
• Black: R5310BK